Configure Localino anchor

You only need this chapter if you use the Localino app.

Configure Localino anchors

1. Open a floor

2. Click on Configure floor [A] ▷ The sidebar changes.

3. Click on Start calibration [B] ▷ Note: If you see the message [G] anchors have already been configured for this floor.

4. In field [C1] specify how high (in meters) the floor of the selected level is above ground.

5. In field [C2] specify how high (in meters) the ceiling of the selected level is above ground.

6. Click on [C3] ▷ The options for the next step appear

7. Select in [D1] at least 2 anchors from

8. Optional: Activate [D2], to filter the list of anchors so that only anchors compatible with the previously entered information are displayed.

9. Click on [D3] ▷ The anchors appear in the viewport [E]. Individual anchors are shown as red dots [E1]

10. Drag and drop the anchors into the desired position. The position of the anchors in Eliona must match the position of the hardware devices as closely as possible. ▷ You can only move/rotate/scale the anchors as a whole. You cannot edit individual anchors. The relative positions of the anchor points were defined beforehand in the Localino app. ▷ You can also rotate and scale the anchor arrangement. If necessary, use [E2] and [E3], to make fine adjustments.

11. Click on Save [F] ▷ The settings are applied

Adjust Localino anchors afterwards

You can adjust the configuration of the Localino anchors afterwards.

1. Open a floor

2. Click on Configure floor [A] ▷ The message [G] appears in the sidebar. If this message is missing, no anchor calibration has yet been performed.

3. Click on Reset [G1] ▷ The message [H] appears

4. Click on [H1] ▷ The position of the anchors is reset. ▷ Any connected Localino trackers will no longer be displayed.

5. Proceed as described in the chapter ↗ Localino Configure anchors.